Teac HS-4000 - Manual (Page 104)

104
TASCAM HS-4000
11 – Internal settings
This setting affects all modes except timeline mode.
Inc. Play
Turn the incremental play function ON or OFF (default).
When incremental play is ON, press the PLAY key during
playback to move to the beginning of the next take and
continue playing, or press the STOP [RETAKE] key during
playback to move to the beginning of the next take and
enter playback standby.
This setting affects all modes except timeline mode.
PLAY Inhibit Time
This sets a time interval during which playback of the same
take (entry) cannot be restarted.
The following keys and commands are disabled (excluding
flash start keys/commands for other takes/entries) for the
duration of this setting. The PLAY key on the front panel
of the unit, the PLAY key, flash start keys and fader start
function of the TASCAM RC-HS32PD remote control (sold
separately), and play and flash start commands from
external controllers (RS-422, RS-232C, parallel, keyboard).
0–1000 msec (100 msec intervals), Inf (during playback the
affected keys are disabled for this amount of time) Default
value: 0 msec
NOTE
When the PLAY Inhibit Time item is set to Inf, the incre-
mental play function is automatically fixed to OFF and
cannot be switched to ON.
Sync and timecode settings (SYNC T/C)
Make various settings related to audio synchronization and
timecode on this page.
This screen has five pages: CLOCK, SYNC, T/C, SETUP and I/O.
Touch the tabs at the bottom of the screen to open the corre-
sponding page.
CLOCK page
View various clock status information and select the clock used
for synchronization.
STATUS
Project
This shows the sampling frequency of the project.
CLOCK
This shows the clock synchronization status.
WORD/VIDEO:
When a synchronization signal is detected at this
connector, WORD, VIDEO or TriLevel is shown.
D-INx ("x" is the channel)
This shows the digital input signal status as follows.
Digital input signal status Display
Locked Locked (xx.xxx kHz)
Sampling rate converter ON Locked (xx.xxx kHz FsCnv)
Unlocked
Unlocked (xx.xxx kHz)
No signal Unlocked (no signal)
No audio signal present Not Audio
Other Cbit information
differs from the actual
operation mode
Unmatched Cbit
MASTER
Use the buttons to select the master clock to use.
p INT button (default):
Use this unit’s internal clock.
p WORD button
Synchronize with the word clock input through the WORD/
VIDEO IN connector.
p VIDEO button
Synchronize with the video clock input through the WORD/
VIDEO IN connector.
p DIN-1/DIN-2 buttons
Synchronize with the clock of the digital signal selected as
the input of DIGITAL IN 1/2.
You cannot select an input as the master clock if the
sampling rate converter is ON for that input.
NOTE
• A mark appears on the button of the currently active
master clock.
• If synchronization from an external clock is interrupted,
the unit’s internal clock becomes active. In this case, the
mark appears on the INT button to show that it has become
the active clock, and the mark appears on the button of
the selected external clock that was lost.
SYNC page
Make settings related to synchronization on this page.