Teac HS-4000 - Manual (Page 110)

110
TASCAM HS-4000
11 – Internal settings
MONITOR PAN
Use these to adjust the stereo position used for monitoring
each channel.
Touch a knob, making its background yellow, and use the
DATA dial to set its stereo position.
Setting range: L100 – C (default) – R100
Defaults: L100 for CH1 and CH3 and R100 for CH2 and CH4
MONITOR MIXER page
Make monitoring mixer settings on this page.
This page differs when in dual and A/B MIXED mode from when
in other operation modes.
When in modes other than dual or A/B MIXED mode
When in dual or A/B MIXED mode
METER buttons
Use these buttons to set whether the meter shows the
position before or after the online fader.
Touch the button on the left to show the level before the
fader or touch the button on the right to show the level after
the fader on the meter.
Post/Pre Fader buttons
Use these buttons to set whether the monitoring output is
from before or after the online fader.
Pre Fader button:
Signals from before the online fader are output for
monitoring.
Post Fader button (default):
Signals from after the online fader are output for monitoring.
Pan knobs
Use these to adjust the stereo position used for monitoring
each channel.
Touch a knob, making its background yellow, and use the
DATA dial to set its stereo position.
Setting range: L100 – C (default) – R100
Defaults: L100 for CH1 and CH3 and R100 for CH2 and CH4
Level knob
Use this to adjust the level of the monitoring output.
Touch this knob, making its background yellow, and use the
DATA dial to adjust the level.
Setting range: 0.0 dB (−∞ , default) – +10 dB
NOTE
If the monitoring mixer overload indicator appears on the
Home Screen, use the level knob to lower the level.
Monitoring mixer overload indicators
If the left or right monitoring mixer channel overloads, the
background of the corresponding L or R becomes red.
SETUP page (MIXER SETUP screen)
Monitor Mute by Online
Set whether monitoring is automatically muted or not
during online playback (default: OFF).
Output 1-4 MonoMix
p OFF button (default): output without mixing to mono.
p L (1, 3) Mono button
The CH1 audio signal is output from both ANALOG LINE OUT 1
and 2 connectors.
The CH3 audio signal is output from both ANALOG LINE OUT 3
and 4 connectors.
p R (2, 4) Mono button
The CH2 audio signal is output from both ANALOG LINE OUT 1
and 2 connectors.
The CH4 audio signal is output from both ANALOG LINE OUT 3
and 4 connectors.
p 1+2/3+4 Mix −3dB button
The CH1 and CH2 audio signals are each attenuated 3 dB, mixed
together and output from both ANALOG LINE OUT 1 and
2 connectors.
The CH3 and CH4 audio signals are each attenuated 3 dB, mixed
together and output from both ANALOG LINE OUT 3 and
4 connectors.
p 1+2/3+4 Mix −6dB button
The CH1 and CH2 audio signals are each attenuated 6 dB, mixed
together and output from both ANALOG LINE OUT 1 and
2 connectors.
The CH3 and CH4 audio signals are each attenuated 6 dB, mixed
together and output from both ANALOG LINE OUT 3 and
4 connectors.