Gasboy CFN Series SCII Start-Up Manual - Manual (Page 92)

CFN Series System
11-6 03/07/03
USING THE CHAIN PUMP FEATURE WITH FUEL POINT
The chain pump feature is used when activation of a fuel dispenser also turns on a bank of fluid
reels. In this application, the dispenser is known as the master of the chain. Only the master of
the chain has a nozzle ring, so its hose must remain in the fill pipe until all fueling and fluid hoses
are finished pumping.
FUEL POINT - GATE ACTIVATION TEST
1. This test should not be run until at least one successful fueling transaction is performed, as in
the tests above.
2. Position the vehicle over the ground loop antenna. Within a few seconds, the gate opener
should operate. Follow the gate opener manufacturer’s operating instructions. Verify that the
system records the correct VM data.