Gasboy CFN Series SCII Start-Up Manual - Manual (Page 71)

Component Power-Up and Configuration
03/07/03 8-11
When the system reboots, it looks first to the A drive. If a release disk is present, that operating
system is loaded. If you made configuration changes to the operating system (on the hard drive)
but did not copy them to the backup 3 1/2" release disk, those changes will not be present and
tables may be reconstructed.
The possible configuration programs are: SYS_PAR, READER, PUMP, CONSOLE, TABLE,
TRFMT, PERM, and GATE. Detailed information on these programs can be found in the
Configuration Manual. The following list contains items which may require changing the site
controller configuration.
•
Use SYS_PAR parameters to change the Site ID #, Switch timeouts, and Pulser timeouts.
•
Serial port configuration. Be sure all devices are plugged into the correct ports, that Link
CRT and Printer are set up according to the instructions earlier in this section.
•
Use pump to check configuration to make sure correct pumps were set up at the factory.
Reassign pump control units if changes were made to previous pump types. Inhouse Dsite
chip may have to be installed if pulse rates need to be changed.
•
If using a network, refer to the Credit and Debit Card Networks Manual, for specific network
configuration considerations.
•
If using Tokheim Dispenser Payment Terminals (DPTs), refer to DPT Instructions available
from GASBOY Technical Service.
•
If using a CheckPoint or Profit Point, refer to the appropriate manuals listed in Section 1 for
any special configuration considerations.
•
If using Gate Reader, it is possible to configure the Prompts and Timeouts parameters.
•
If using a tank monitoring system, it is possible to configure the add to inventory and log
delivery parameters.
•
If using the Islander with key option, refer to the Configuration Manual for: SYS_PAR
changes to club card format field widths and offsets, parameters pertaining to PIN
verification, and MPG package settings, and for READER program changes to Enter PIN and
Enter Odometer. The READER program must also include the REMOVE CARD/KEY step.
The software for the Islander II is supplied on a PCMCIA 2Mb SRAM card and also on a backup 3
1/2" disk. During normal system use, any configuration changes, command files, etc. that you
add to the CFN system are automatically placed on the card. These changes must be copied
onto the backup 3 1/2" disk to keep your backup current. A second PCMCIA card slot is available
to allow you to back up one card to another, if a second PCMCIA card is available.
SERIES 9800 ELECTRONIC PUMPS AND DISPENSERS
If you are using Series 9800 pumps and dispensers, there are switches that must be set correctly
to insure proper operation of your CFN system. See the Series 9800 Installation/Operation
Manual for details.