Gasboy CFN Series SCII Start-Up Manual - Manual (Page 70)

CFN Series System
8-10 03/07/03
Okidata 184 Setup
To prepare the Okidata printer for operation with the LINK MC5 terminal and your GASBOY Fuel
Management System, perform the following steps. Install and complete the setup of the printer as
specified in the manufacturer's setup instructions. Then set up the switches as follows:
SW1-1 ON Parity: Odd
SW1-2 ON Parity: Without
SW1-3 ON Data bits: 8
SW1-4 OFF Protocol: XON/XOFF
SW1-5 ON Test select: Circuit
SW1-6 ON Mode select: Print
SW1-7 ON Busy line selection: DTR - Pin 20
SW1-8 ON Busy line selection: DTR - Pin 20
SW2
Baud Rate
SW2-1 SW2-2 SW2-3
9600 OFF ON ON
2400 OFF OFF ON
1200 ON ON OFF
300 ON OFF OFF
NOTE: Any change made to the baud rate must also be changed on the Link terminal
Communications Setup screen, Aux Baud parameter.
SW2-4 ON DSR output signal: Active
SW2-5 ON Buffer threshold: 32 bytes
SW2-6 OFF Busy signal timing: 1 sec (min.)
SW2-7 ON DTR signal: Space after power on
SW2-8 OFF Not used
1. Turn the printer offline by pressing SELECT. The SELECT light should go off.
2. Position the print head at the top of the paper and press the TOF SET button.
3. Put the printer back online by pressing SELECT. The SELECT light should go on.
4. Press the MODE button until the light next to HSD is lit.
5. Press the PITCH button until the light next to 17 is lit.
NOTE: Pitch may be set to a lower number (resulting in larger print) if transactions are less
than 80 characters.
SITE CONTROLLER CONFIGURATION CHANGES
Although the system has already been configured and tested at the factory, you may need to
perform some configuration changes to match the site's characteristics. Follow the instructions in
the Site Controller II Configuration Manual to make these changes.
The software for a CFN system with a 3 1/2" disk drive and a hard disk is supplied on the hard
disk and also on a backup 3 1/2" disk. During normal system use, any configuration changes or
command files, etc. that you add to the CFN system are automatically place on the hard disk.
These changes must be copied onto the backup 3 1/2" disk to keep your backup current.