Gasboy CFN Series SCII Start-Up Manual - Manual (Page 31)

Begin Start-up Form
03/07/03 3-3
RESET: The type of reset used in the pump (Veeder-Root, Tokheim #77,
etc.)
TYPE SUC/SUB: The type of pump used to dispense the fuel. Submersible pump
(SUB) located in the tank or is it a suction pump (SUC) located in
the pump housing? Circle one.
TYPE PULSER: The type of pulser used and the wheel of the register on which
the pulser is located (e.g., $=dollar, G=gallon).
PULSER RATE: The pulser rate of the pulser used by that pump or dispenser
(e.g., 10:1, 100:1).
STARTER RELAY: Is an external starter relay used to supply power to the pump.
Circle Y for yes or N for no.
✍
4. COMMUNICATIONS
Data Terminal/Logger/Logger Eliminator:
Circle the device and indicate the make and model number of the
data terminal or logger connected to the system. If a data
terminal or logger is not being used, a logger eliminator (P/N
C05593) must be connected to port 0. The Islander does not
require a logger eliminator, but if no terminal or logger is
connected, circle logger eliminator on the form anyway.
Port # Baud Rate
Local
0: Baud rate for port 0.
1: Baud rate for port 1.
Remote 2: Baud rate for port 2.
3: Baud rate for port 3.
Short Haul Modem: The make and model number of the short haul modem that is
connected to the system. If no short haul modems are used,
indicate not applicable (N/A).
Phone Modem: Port The make of the phone modem and the port it is connected to. If
the Islander internal modem is used, write internal on the form.
Modem Phone #: The area code and phone number for the phone modems
connected to the system. If a modem is not used, indicate not
applicable (N/A).
Network Name Port The name of the network that the site is connecting to (if
applicable) and the port through which it is communicating.