Gasboy CFN Series SCII Start-Up Manual - Manual (Page 106)

CFN Series System
13-2 03/07/03
✍
10. SYSTEM APPROVALS
Note any remarks or comments from the customer in the space provided.
Have a responsible contact person sign the Start-up form and sign it yourself. This indicates that
the system has been accepted by the customer and the installation is approved by you.
❑ Demonstrate how to clean the reader at the Islander or island card reader unit.
Optical Card Reader:
a. Wrap a lint free cloth around an access card. Do not use paper. It may tear and cause
read errors.
b. Insert the card lengthwise and move it from side to side.
Magnetic Card Readers
a. Use the GASBOY cleaning card. Order GASBOY P/N C08757 for a box of 50 cleaning
cards.
b. Slide the cleaning card through several times.
c. Turn the card around and slide it through several times. By turning the card around, you
will use the entire cleaning area.
d. Clean the card reader at least once a week. The frequency of cleaning required
depends on the environment the system is in and how heavily it is used. Failure to
clean the card reader regularly could result in premature failure.
❑ Demonstrate how to clean the fan filter element in the Site Controller II. Use mild soap and
water solution or replace with GASBOY P/N C09109.
❑ Demonstrate how to clean the disk drive using the GASBOY disk cleaning kit (P/N C01770)
GASBOY recommends that you clean your disk drive at least once a week, although more
frequent cleaning may be necessary in high dirt or dust areas.
a. Remove the contents of the disk cleaning kit from the box. The drive cleaning kit, if used
as directed, will last one year.
b. The disk drive on the Site Controller II is a dual-sided drive. Remove the pressure arm on
the cleaning diskette by bending it back until it snaps off. CAUTION: Once the pressure
arm has been removed, do not use this cleaning kit for a single-sided drive.
c. Open the bottle of cleaning fluid and fully saturate the area exposed in each of the two
large cutouts.
d. Insert the cleaning diskette into the drive with the number of uses label facing up.
e. At the data terminal or CRT, sign on, type FORMAT and press RETURN. The Site
Controller prompts you for the drive letter.
f. Type A or B, depending on the drive to be cleaned, and press RETURN. The Site
Controller prompts you for Type.