Gasboy CFN Series SCII Start-Up Manual - Manual (Page 101)

Start-up Commands
03/07/03 12-9
36. If you use the MPG option, type LO V;IC
to clear the vehicle file and load vehicles
and odometer readings.
A*LO V;IC
↵
Vehicle number? 100
↵
Odometer reading? 22954
↵
Vehicle number?
↵
A*
Reset Transaction File
37. The following command sequence enables
you to reset and initialize the transaction
file. It is explained following the example.
CAUTION, this command procedure
should only be done at start-up.
A*FIX TR;I
↵
Verify (y/n) y
↵
A*RE TR;A
↵
Verify (y/n) y
↵
A*RE TR;I
↵
Verify (y/n) y
↵
A*LO TR 0
↵
A*RE TR 1
↵
Verify (y/n) y
↵
A*
Explanation of commands:
FIX TR;I Resets the transaction file and sets all transaction numbers to -1. Use this command
only at start-up as it is irreversible; all stored transactions will be made unreadable.
Answer yes, y, to the VERIFY prompt and press RETURN.
RE TR;A Resets all transaction file pointers.
RE TR:I Clears any temporary or transaction in progress files.
LO TR 0 Loads a new transaction number of 0 (zero).
RE TR 1 Resets the transaction pointer to begin at transaction 1.
Diagnostics and History
38. Type RE DI;I to set the diagnostic error
totals to zero.
A*RE DI;I
↵
A*
39. Type E HI;I to enable history recording.
This is initialized when you receive the
system, but it will contain every command
you just performed. Enabling it here lets
you start-up the history with a clean slate.
A*E HI ; I
↵
A*
40. Type RUN;I to start the site.
A*RUN;I
↵
Verify (y/n) y
A*