Gasboy CFN Series SCII Start-Up Manual - Manual (Page 19)

Site Information
03/07/03 2-7
11. LOAD CUTOFF (Reference: Site Manager's Manual, LO CU command)
Use this table to note the amount the Site Controller will authorize or request authorization for
when a customer requests a FILL. When you encode a limitation code on privately-issued
cards, that code overrides the pump fill limit. Also indicate on this table, the slow cutoff point,
at which the pump will slow prior to reaching the fill limit.
PUMP
NUMBER
FILL
LIMIT
SLOW
CUTOFF
12. LOAD TAX (Reference: Site Manager's Manual, LO TAX command)
Use the following table to enter the names of the tax accumulators. Tax accumulators keep
a running total of taxes collected in up to eight categories. Tax formulas are specified in
system configuration or by using the TAX command.
Tax # Name (up to 7 chars.)
13. LOCKOUT TYPE (Reference: Site Manager's Manual: LOC CA or UN CA commands)
Indicate type of lockout: ______ Positive ______ Negative
14. AUTHORIZATION AND LIMITATION CODES (Reference: Card Encoding Manual, Site
Manager's Manual, LO A, LO LI commands)
If the customer is using private-issue cards, you may also need to load authorization codes
and limitation codes for the cards. Values for these codes should have been assigned when
the cards were encoded. Special templates for defining these codes appear in the Card
Encoding Manual.