Epiphan Pearl User Manual

Page 72

Pearl User Guide

Configure a static IP address

4. Select the radio button use static address, if not already selected.

5. Enter the desired IP Address and Network Mask.

Only IPv4 addresses are supported.

6. Enter the Default Gateway address. If you do not have a default gateway for your network, enter the

same static IP address as in the previous step.

The default gateway cannot be left blank. If no default gateway is specified, unexpected
behavior occurs.

7. Enter the DNS Server address. If you do not have a DNS server, enter the new static IP address of the

system.

8. Change the MTU Size value only if needed. See the table below for information on maximum

transmission unit (MTU) values.

9. Click Apply to save the changes; the changes are saved and a message appears asking you to reboot.

10. Select the Maintenance link under the Configuration menu; the maintenance page appears.

11. Click the Reboot Now button near the bottom of the page.