Epiphan Pearl User Manual
Page 261
Pearl User Guide
AFU using RSync
2. Specify the target Server address. If your system is configured with DHCP or has a valid DNS
), you can use the server’s fully qualified domain name instead of
the IP address.
3. Specify the Server module. This is the name of the shared folder on the server. If needed, request this
value from your network administrator.
4. Specify a username for the RSync Server in the Login field. The user must have write permissions for
the module.
5. Specify the password for the user in the Password field; the value is masked by dots.
6. If desired, select the Checksum check box to add a checksum validation to the transfer between the
system and the recipient server.
7. Click Apply; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to an RSync server.
Table 29
RSync Automatic File Upload Configuration Options
Name
Description / Options
Server
address
The IP address (or fully qualified domain name) of the RSync server.
Server module The name of the shared folder on the RSync server.
Login
Username for the RSync server.
Password
Password for the RSync user.
Checksum
Select to enable checksum checking during file transfer. This increases the time taken to
transfer, but also increases reliability of the transfer.
248