Afu using rsync – Epiphan Pearl User Manual
Page 260
Pearl User Guide
AFU using RSync
4. Enter the FTP account username in the Login field.
5. Enter the FTP account password in the Password field; the characters are masked with dots.
6. Select Use temp file to name files with a temporary filename extension (.part) on the server until
upload is complete.
7. Click Apply; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to an FTP server.
Table 28
FTP Automatic Upload Configuration Options
Name
Description / Options
Server
address
The IP address (or fully qualified domain name) of the FTP server.
Server port
The port used by the target FTP server. Standard port is 21.
Login
Username for the FTP server.
Password
Password for the FTP user.
Use temp file
Causes files to be named with .part extension on the server during active upload. When
the upload completes, the file is renamed to the appropriate extension (.mov, .mp4 or
.avi).
AFU using RSync
This procedure assumes you have completed the steps in
with configuration of upload using RSync.
To configure upload using RSync:
1. Select RSync Client from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
247