Afu to a secure ftp server – Epiphan Pearl User Manual
Page 263
Pearl User Guide
AFU to a secure FTP server
9. Click Apply; if there are any problems the system notifies you with a message: One or more parameter
values are not valid and those were not applied!
The following table describes the options applicable to configuring upload to a CIFS server.
Table 30
CIFS Automatic File Upload Configuration Options
Name
Description / Options
Server Port
The CIFS server port. Leave blank to use the default port, or enter the port used for your
CIFS server.
Server
address
The IP address (or fully qualified domain name) of the CIFS server.
Server share
The name of the shared folder on the CIFS server.
Domain
The CIFS server's Windows domain or Work Group name . Needed if the server is part of
Active Directory or a Domain Controller.
Login
Username for the CIFS server.
Password
Password for the CIFS user.
Use temp file
Causes files to be named with .part extension on the server during active upload. When
the upload completes, the file is renamed to the appropriate extension (.mov, .mp4, .ts or
.avi).
AFU to a secure FTP server
This procedure assumes you have completed the steps in
with configuration of upload to a secure FTP Server (SFTP).
To configure upload to a secure FTP (SFTP) server:
1. Select SFTP Client from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
250