Epiphan Pearl - Manual (Page 259)

Pearl User Guide AFU to an FTP server
Name Description
External
USB Drive
The system uploads to a USB drive connected directly to the system.
10. Follow one of the procedures below to configure your selected protocol or transfer type.
l
AFU to an FTP server
l
AFU using RSync
l
AFU using CIFS
l
AFU to a secure FTP server
l
AFU using SCP
l
AFU or copy to USB drive
AFU to an FTP server
This procedure assumes you have completed the steps in Enable and set timing for AFU and wish to continue
with configuration of upload to an FTP Server.
To configure upload to an FTP server:
1. Select FTP Client from the protocol drop down list in the Automatic File Upload configuration page;
the lower half of the page reflects the selection.
2. Specify the target Server address. If your system is configured with DHCP or has a valid DNS
configuration (see Configure DHCP ), you can use the server’s fully qualified domain name instead of
the IP address.
3. Specify the Server Port used for the target FTP server. The standard port is 21.
246