Epiphan Pearl - Manual (Page 69)

Pearl User Guide Configure DHCP
5. If not already using DHCP, touch DHCP to enable DHCP.
6. If DHCP was not the active network type, a confirmation message is displayed.
7. Touch OK; DHCP is enabled.
To configure use of DHCP for networking:
1. Connect to the admin interface using your preferred connection mechanism. See Connect to the admin
interface .
2. Login as admin.
3. Select the Network link in the Configuration menu; the network configuration page opens.
4. Select the radio button use DHCP, if not already selected.
5. Change the MTU Size value only if needed. See the table below for information on maximum
transmission unit (MTU) values.
6. Click Apply to save the changes; the changes are saved and a message appears asking you to reboot.
7. Select the Maintenance link under the Configuration menu; the maintenance page appears.
8. Click the Reboot Now button near the bottom of the page.
9. Wait for the system to reboot.
10. Connect to the admin interface using your preferred connection mechanism. See Connect to the admin
interface .
11. Log as admin and reload the Networking page to verify all changes were applied.
The following table describes the fields applicable when configuring DHCP on Pearl.
56