5 loop formation (loop), Introduction, 1 intended use – Pilz PNOZ m1p base unit User Manual
Page 66: 5loop formation (loop), 1 introduction
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-1
5.1
Introduction
5
Loop formation (LOOP)
5
5000
Loop formation (LOOP)
Loop formation (LOOP)
5-
5.1
Introduction
5100
Introduction
5-
Schleifenbildung_Einführung
This chapter describes the "Loop formation" function, in which LOOP in-
puts and outputs are configured in the PNOZmulti Configurator. This
function is available from Version 8.1.0 of the PNOZmulti Configurator.
Details of which base units support Version 8.1.0 are available in the
"Product Modifications" document in the "Version overview" section.
5.1.1
Intended use
Intended use
5-
Schleifenbildung_Bestimm_Verwendung
The loop formation (LOOP) function is used to feedback output informa-
tion to the inputs.
NOTICE
When forming a loop, please note that the switch-off delay of the
connected output is increased (see section entitled "Function
description").