Pilz PNOZ m1p base unit - Manual (Page 3)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
1
Contents
Contents
Contents Page
Chapter 1 Introduction
1.1 Overview of documentation 1-1
1.2 Definition of symbols 1-2
Chapter 2 Muting
2.1 Introduction 2-1
2.2 Safety 2-2
2.2.1 Intended use 2-2
2.2.2 Standards 2-2
2.2.3 Safety guidelines 2-2
2.3 Configuration in the PNOZmulti Configura-
tor 2-4
2.3.1 Functions 2-4
2.3.2 Input parameters 2-4
2.3.3 Output parameters 2-4
2.3.4 Monitoring times 2-5
2.3.5 Suspension of muting (override) 2-5
2.3.6 Reset 2-6
2.3.7 Restarting the muting time 2-6
2.4 Operating modes 2-7
2.4.1 Terminology 2-7
2.4.2 Sequential muting 2-7
2.4.2.1 Position of the muting sensors 2-7
2.4.2.2 Switch conditions in sequential mode 2-8
2.4.2.3 Sequence errors 2-9
2.4.2.4 Diagnostic word 2-10
2.4.2.5 Timing diagram (example) 2-10
2.4.3 Parallel muting 2-11
2.4.3.1 Position of the muting sensors 2-11
2.4.3.2 Switch conditions in parallel mode 2-12
2.4.3.3 Diagnostic word 2-12
2.4.3.4 Timing diagram (example) 2-13
2.4.4 Cross muting 2-14
2.4.4.1 Position of the muting sensors 2-14
2.4.4.2 Switch conditions in cross mode 2-15
2.4.4.3 Diagnostic word 2-16
2.4.4.4 Timing diagram (example) 2-16
Chapter 3 Safety Mat/Safe Edge
3.1 Introduction 3-1
3.2 Safety 3-2
3.2.1 Intended use 3-2
3.2.2 Safety guidelines 3-2