Pilz PNOZ m1p base unit - Manual (Page 15)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
2-7
2.4 Operating modes
2 Muting
2.4 Operating modes 2400 Operating modes 2- Muting_Betriebsarten
The following operating modes can be implemented:
 Sequential muting
 Parallel muting
 Cross muting
2.4.1 Terminology
Terminology 2- Muting_Betriebsarten_Begriffsbestimmungen  Muting On
"Muting On" is the switch condition for switching on the muting func-
tion. When muting is switched on, the Muting active output parame-
ter has a 1 signal and time monitoring runs.
 Muting Off
"Muting Off" is the switch condition for ending the muting function.
When the muting function is ended, output parameter Muting active
has a 0 signal.
WARNING!
"During muting safe conditions shall be provided by other
means" (EN 954-1). For example, this may be achieved by the
conveyed item blocking access to the danger zone. Even open-
ings in or between the individual parts of the conveyor flow must
never enable access.
INFORMATION
You will find important additional information on the use of sen-
sors or contacts in the section entitled "Safety".