Pilz PNOZ m1p base unit - Manual (Page 14)

2.3 Configuration in the PNOZmulti Configurator
2 Muting
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
2-6
2.3.6 Reset
Reset 2- Muting_Konfiguration_Reset
Reset resets the muting element after a fault or during start-up if
 no muting sensor is operated
and
 the light curtain is clear.
2.3.7 Restarting the muting time
Restarting the muting time 2- Muting_Konfiguration_Neustart der Muting-Zeit
Reset resumes muting and restarts the muting time if
 muting was ended as a result of the muting time having elapsed (e.g.
by the conveyor feed stopping)
and
 the muting sensors are returning feasible signals and the light curtain
has not been interrupted.
CAUTION!
The following additional safety requirements apply to the muting
override:
– The override switch must have a hold-to-run control device
(touch-operated switch).
– The override switch must be installed in a fixed position out-
side the danger zone.
– The danger zone and the muting station must be visible
from the override switch position.
– The danger zone must be identified as clear before the over-
ride switch is operated and while it is operated.
CAUTION!
The following additional safety requirements apply for the reset
button:
– The danger zone and the muting station must be visible
from the reset button position.
– The reset button may not be operated until the danger zone
has been viewed and has been identified as clear.