Pilz PNOZ m1p base unit - Manual (Page 4)

Contents
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
2
3.3 Function description 3-3
3.4 Configuration in the PNOZmulti Configura-
tor 3-4
3.4.1 Allocation of test pulses to inputs 3-4
3.5 Commissioning the safety system 3-5
3.5.1 Preparing for commissioning 3-5
3.5.2 Preparing for operation 3-5
3.6 Operation 3-7
3.6.1 Diagnostic word 3-7
3.7 Technical Details 3-8
Chapter 4 Burners
4.1 Introduction 4-1
4.2 Safety 4-2
4.2.1 Intended use 4-2
4.3 Configuration in the PNOZmulti Configura-
tor 4-3
4.3.1 Functions 4-3
4.3.2 Monitoring functions/settings for the burn-
er cycle 4-4
4.3.2.1 Combustion air pressure monitoring, acti-
vating the combustion air blower, com-
pound controller monitoring 4-4
4.3.2.2 Ignition 4-5
4.3.2.3 Flame monitoring 4-5
4.3.2.4 Compound controller 4-6
4.3.2.5 Tightness control 4-6
4.3.2.6 High temperature 4-7
4.3.2.7 Plant-dependent monitoring functions 4-8
4.3.2.8 Shutdown types 4-8
4.3.2.9 Step times 4-9
4.4 Burner cycle 4-11
4.4.1 Steps 4-11
4.4.2 Errors during the burner cycle 4-11
4.4.3 Master burner with direct ignition 4-12
4.4.4 Master burner with separate flame moni-
toring 4-14
4.4.5 Master burner with joint flame monitoring 4-16
4.4.6 Slave burner with direct ignition 4-17
4.4.7 Slave burner with separate flame monitor-
ing 4-17
4.4.8 Slave burner with joint flame monitoring 4-18
4.4.9 Example: Viewing the burner cycle in the
PNOZmulti Configurator 4-19
4.5 Inputs and outputs 4-22
4.5.1 Element's inputs 4-22