Pilz PNOZ m1p base unit - Manual (Page 12)

2.3 Configuration in the PNOZmulti Configurator
2 Muting
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
2-4
2.3 Configuration in the PNOZmulti Configurator 2300 Configuration in the PNOZmulti Configurator 2- 2.3.1 Functions
Functions 2- Muting_Konfiguration_Funktionen  Muting via light beam devices or limit switches
 Override option in case of fault
 Max. muting time can be set
 Muting sensors can be monitored for simultaneity
 Configuration of bounce time for contact-based muting sensors
 Sequence of the muting sensors can be monitored
 Operating modes
– Sequential muting
– Parallel muting
– Cross muting
2.3.2 Input parameters
Input parameters 2- Muting_Konfiguration_Eingangsparameter  Muting sensor 1
N/O contact of muting sensor 1
Muting sensor 1 = 0: Not operated
Muting sensor 1 = 1: Operated
 Muting sensor 2
N/O contact of muting sensor 2
Muting sensor 2 = 0: Not operated
Muting sensor 2 = 1: Operated
 Light curtain
Light curtain = 0: Interrupted
Light curtain = 1: Not interrupted
Assign the light curtain input parameter to the output of the light cur-
tain function element. The light curtain function element must be
configured with an automatic reset.
 Muting sensor 3
N/O contact of muting sensor 3
Muting sensor 3 = 0: Not operated
Muting sensor 3 = 1: Operated
 Muting sensor 4
N/O contact of muting sensor 4
Muting sensor 4 = 0: Not operated
Muting sensor 4 = 1: Operated
 Muting override
Muting override = 1: Suspend the muting function if a fault occurs
(override) to override the muting channel.
 Reset = 0/1 pulse edge: Reset muting after an error or start the muting
time.