ebm-papst ECI-63.XX-K4 - Manual (Page 95)

95
10 Parameter Description
Parameter 0x6: Restart
Description: The “restart” parameter is used to configure the behaviour according following safety-critical errors. The drive cannot be operated while
safety-critical errors are queued. If there are no longer any safety-critical errors, the drive can be switched ready for use automatically or manually via an
acknowledgement.
Parameter 0x7, 0x8, 0x9, 0xA: intentionally left blank
Parameter 0xB: FE_DREHZAHL_X1
Description: X1 interpolation point in the target value characteristic curve.
Parameter 0xC: FE_DREHZAHL_X2
Description: X2 interpolation point in the target value characteristic curve.
Parameter 0xD: FE_DREHZAHL_X3
Description: X3 interpolation point in the target value characteristic curve.
Parameter 0xE: FE_DREHZAHL_Y0
Description: Target speed below the first interpolation point.
Parameter 0xF: FE_DREHZAHL_Y1
Description: Target speed value for interpolation point X1.
Parameter 0x10: FE_DREHZAHL_Y2
Description: Target speed value for interpolation point X2.