ebm-papst ECI-63.XX-K4 - Manual (Page 105)

105
10 Parameter Description
Parameter 0x4F: Temperature signal threshold
Description: The temperature signal threshold parameter defines from which temperature value the temperature signal output is activated.
Parameter 0x50: Temperature signal delta hysteresis
Description: The parameter is to be understood as being an absolute delta value, which specifies the absolute threshold “temperature signal threshold
– hysteresis temperature signal delta”.
E.g.:
Temperature signal threshold = 70°C
Hysteresis temperature signal delta = 3°C
Here the lower hysteresis threshold of the temperature signal is 67°C = (70 – 3)
Parameter 0x51: Transmission ratio
Description: The transmission ratio factor contains a conversion factor which allows the speed at the transmission output to be deduced.
Parameter 0x52: Bus address
Description: The parameter contains the slave address of the drive. Under this address the drive can be addressed via RS485.
Parameter 0x8001: Current actual speed
Description: The parameter contains the current actual speed. The speed is output in revolutions / minute.
Parameter 0x8002: Current winding current
Description: The parameter contains the current actual current, which is calculated as the vector addition of I
q
and I
d
.
Parameter 0x8003: Current actual position LoByte
Description: The parameter contains the current actual position.
Parameter 0x8004: Current actual position HiByte
Description: The parameter contains the current actual position.