ebm-papst ECI-63.XX-K4 - Manual (Page 11)

11
2 Safety Instructions
2.6 electrical / electromagnetic safety
• Check the electrical equipment of the drive system regularly.
• Only use cables and connectors approved by ebm-papst.
• Remove defective cables and loose connections immediately.
• Take suitable measures to avoid impermissible electromagnetic interference emissions.
• Take suitable measures against high-frequency EMC radiation.
• Ensure EMC capability in the terminal device / installation state.
• Use control devices to control the electromagnetic radiation.
2.7 Mechanical safety
• Only carry out work when the system / machine is at a standstill.
• Provide adequate cooling of the drive.
• Remove protective devices and guards on the drive system and design application only for the purpose of carrying out repair and
assembly work.
2.8 Intended use
• The drives of the VDC-3-49.15-K4 and ECI-63.XX-K4 series are intended for installation in stationary industrial design applications and
machines and may only be operated electrically when installed!
• Commissioning or starting up is therefore prohibited until it has been established that the drive system together with the design
application, in which the drive is installed, satisfy the safety and protection requirements of the Machinery Directive.
• This product is not intended for consumers! Use in a home environment is not planned, without further testing and deployment of
appropriately adapted EMC protection measures!
• The electronic module is an installation product. It is only intended for use within other equipment or units and has no independent
function. It is not intended for passing on to end users or consumers.
• All motor - electronic combinations must be qualified by the end manufacturer within their intended application and validated for overload
and blocking safety. The application manufacturer is responsible for the end product and must ensure that adequate safety precautions
are taken.
2.8.1 Type-related exclusion
Due to its type or design, the drive system must not be used in the following areas of use; this could result in and hazards and equipment
damage:
• In case of special fail-safe requirements.
• In aircraft and space vehicles.
• In rail and motor vehicles.
• In boats and ships.
• In potentially explosive atmospheres (EX protection area).
• For operation near flammable materials or components.
• For use as a safety component or for carrying out safety-relevant functions.