Cub Cadet 8454 - Manual (Page 295)

BRAKE
7-15 D569-W02 May-2003
It is Possible to Disassemble as Shown in the
Figure Above.
(When reassembling)
• Place the brake discs (9) so that the hole “A” of the
second disc should be overlapped 70% or more.
• Apply grease to the O-ring (12) and take care not to
damage them.
Brake Case
1. Loosen and remove the nut (1), spring washer (2),
plain washer (3), brake can lever (4), bolt (5) and
spring washer (6).
2. Separate the brake case (7), tapping the brake case
lightly.
(When reassembling)
• Apply grease to the brake ball seats (16).
(Do not grease excessively.)
• Before installing the brake case (7) to the transmis-
sion case, install the cam plate (14) to the trans-
mission case.
(1) Nut (9) Disc
(2) Spring Washer (10) Plate
(3) Plain Washer (11) Snap Ring
(4) Brake Cam Lever (12) O-Ring
(5) Bolt (13) Brake Cam
(6) Spring Washer (14) Cam Plate
(7) Brake Case (15) Ball
(8) Gasket (16) Ball Seat
5.5 DISASSEMBLING BRAKE CASE
Tightening
torque Brake case
mounting bolt,
nut
Brake cam lever
mounting nut
77.5 ~ 90.2 N·m
7.9 ~ 9.2 kgf·m
57.1 ~ 66.5 lbf·ft
123.6 ~ 147.1 N·m
12.6 ~ 15.0 kgf·m
91.1 ~ 108.5 lbf·ft
569W725A
569W726A