CANOGA PERKINS 9175 Configuration Guide - Manual (Page 83)

CanogaOS Configuration Guide
12-6
12.7 Remote Failure Detection Configuration
An error-disable action can be configured to occur on an interface so that if any of the
critical link events (link fault, dying gasp, etc.) occurs in the remote machine, the
interface is shut down.
DUT# configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-9 Specify the interface (eth-0-9) to be
configured and enter the Interface mode.
DUT(config-if)# ethernet oam remote-failure critical event
dying-gasp link-fault action errordisable-interface
Configure the Ethernet OAM
remote-failure action on eth-0-9.
Configure the interface to shut down
when any of the critical link events take
place on the remote machine.
DUT(config-if)# end Exit the Interface mode.
Validation
When a remote failure action (error-disable-interface) is configured in Bridge1 and when
a critical link event
(Link fault, dying gasp, or other critical event) occurs in Bridge2, the interface is disabled
(shut down).