CANOGA PERKINS 9175 Configuration Guide - Manual (Page 160)

CanogaOS Configuration Guide
25-5
64 bytes from 4.4.4.1: icmp_seq=1 ttl=63 time=240 ms
64 bytes from 4.4.4.1: icmp_seq=2 ttl=63 time=261 ms
64 bytes from 4.4.4.1: icmp_seq=3 ttl=63 time=251 ms
64 bytes from 4.4.4.1: icmp_seq=4 ttl=63 time=217 ms
--- 4.4.4.1 ping statistics ---
5 packets transmitted, 5 received, 0% packet loss, time 4061ms
rtt min/avg/max/mdev = 217.441/247.466/265.920/17.374 ms, pipe 2
Switch B output
Check the route on Switch B
DUT1#show ip route
Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
[*] - [AD/Metric]
* - candidate default
R 1.1.1.0/24 [120/2] via 2.2.2.2, eth-0-20, 00:21:18
C 2.2.2.0/24 is directly connected, eth-0-20
R 3.3.3.0/24 [120/3] via 2.2.2.2, eth-0-20, 00:21:18
C 4.4.4.0/24 is directly connected, eth-0-1
K 192.168.100.0/24 is kernel directly connected, management interface
Ping Switch A
DUT1#ping 1.1.1.1
PING 1.1.1.1 (1.1.1.1) 56(84) bytes of data.
64 bytes from 1.1.1.1: icmp_seq=0 ttl=63 time=278 ms
64 bytes from 1.1.1.1: icmp_seq=1 ttl=63 time=291 ms
64 bytes from 1.1.1.1: icmp_seq=2 ttl=63 time=268 ms
64 bytes from 1.1.1.1: icmp_seq=3 ttl=63 time=279 ms
64 bytes from 1.1.1.1: icmp_seq=4 ttl=63 time=267 ms
--- 1.1.1.1 ping statistics ---
5 packets transmitted, 5 received, 0% packet loss, time 4070ms
rtt min/avg/max/mdev = 267.926/277.377/291.711/8.705 ms, pipe 2
Switch C output
Check the route on Switch C
DUT1#show ip route
Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
[*] - [AD/Metric]
* - candidate default
C 1.1.1.0/24 is directly connected, eth-0-9
C 3.3.3.0/24 is directly connected, eth-0-1
K 192.168.100.0/24 is kernel directly connected, management interface
Switch B and Switch C are in different VRF, so Switch C can’t ping Switch B’s address
DUT1#ping 4.4.4.1
connect: Network is unreachable
Switch D output