3 configuring interface duplex – CANOGA PERKINS 9175 Configuration Guide User Manual
Page 16
CanogaOS Configuration Guide
1-2
1.2.2 Configurations
Bridge 1
DUT#configure terminal
Enter the Configure mode.
DUT(config)#interface eth-0-1
Enter the interface mode.
DUT(config-if)#speed 100
Set interface eth-0-1 speed to 100M.
DUT(config-if)#interface eth-0-2
Enter the interface eth-0-2.
DUT(config-if)#speed 1000
Set interface eth-0-2 speed to 1000M.
DUT(config-if)#interface eth-0-3
Enter the interface eth-0-3.
DUT(config-if)#speed auto
Set interface eth-0-3 speed to auto negotiation.
DUT(config)#end
Exit to exec mode.
DUT#show interface status
Display interface speed.
1.2.3 Validation
Commands
Bridge 1
DUT#show interface status
Port Status Duplex Speed Mode Type
------------------------------------------------------------
eth-0-1 up a-full 100 access 1000BASE_T
eth-0-2 up a-full 1000 access 1000BASE_T
eth-0-3 up a-full a-1000 access 1000BASE_T
1.3 Configuring Interface Duplex
1.3.1 Topology
Figure 1-3: Interface Duplex
1.3.2 Configurations
Bridge 1
DUT#configure terminal
Enter the Configure mode.
DUT(config)#interface eth-0-1
Enter the interface mode.
DUT(config-if)#duplex full
Set interface eth-0-1 duplex to full.
DUT(config-if)#interface eth-0-2
Enter the interface eth-0-2.
DUT(config-if)#duplex half
Set interface eth-0-2 duplex to half.
DUT(config)#interface eth-0-3
Enter the interface eth-0-3.
DUT(config-if)#duplex auto
Set interface eth-0-3 duplex to auto negotiation.
DUT(config-if)#end
Exit to exec mode.