CANOGA PERKINS 9175 Configuration Guide User Manual
Page 54
CanogaOS Configuration Guide
9-8
DUT(config) # interface eth-0-13
Enter the Interface mode.
DUT(config-if)#switchport mode trunk
Set the switching characteristics of this interface to
trunk mode.
DUT(config-if)#switchport trunk allowed vlan add
11,12
Enable VLAN 11, 12 on this port.
DUT(config-vlan) # exit
Exit the interface mode and enter the Configure mode.
Configure and enable ERPS domain
DUT(config) # erps 1
Create erps domain with id 1.
DUT(config) # erps 1 primary control vlan 11
Set vlan 11 as the primary control vlan of erps domain
1.
DUT(config) # erps 1 sub control vlan 12
Set vlan 12 as the sub control vlan of erps domain 1.
DUT(config) # erps 1 ring 1 level primary
Create an erps primary ring 1 for domain 1.
DUT(config) # erps 1 ring 1 mode master
Set node as master of ring 1 for domain 1.
DUT(config) # erps 1 ring 1 primary interface eth-0-9
Set primary interface of ring 1 for domain 1.
DUT(config)# erps 1 ring 1 secondary interface eth-0-13
Set secondary interface of ring 1 for domain 1.
DUT(config) # erps 1 ring 1 enable
Enable ring 1 for domain 1.
DUT(config) # erps 1 enable
Enable domain 1.
Switch 2
Create VLANs for transferring ERPS control packets
DUT# configure terminal
Enter the configure mode.
DUT(config) # vlan database
Enter VLAN database mode.
DUT(config-vlan) # vlan 11,12
Creat vlan 11, 12.
DUT(config-vlan) # exit
Exit the vlan mode and enter the Configure mode.
Configure interface eth-0-9
DUT(config) # interface eth-0-9
Enter the Interface mode.
DUT(config-if)#switchport mode trunk
Set the switching characteristics of this interface to
trunk mode.
DUT(config-if)#switchport trunk allowed vlan add
11,12
Enable VLAN 11, 12 on this port.
DUT(config-vlan) # exit
Exit the interface mode and enter the Configure mode.
Configure interface eth-0-20
DUT(config) # interface eth-0-20
Enter the Interface mode.
DUT(config-if)#switchport mode trunk
Set the switching characteristics of this interface to
trunk mode.
DUT(config-if)#switchport trunk allowed vlan add
Enable VLAN 11, 12 on this port.