CANOGA PERKINS 9175 Configuration Guide - Manual (Page 43)

CanogaOS Configuration Guide
8-3
DUT# configure terminal Enter the Configure mode.
DUT(config-if)# switchport trunk allowed vlan all Configure vlans that allowed passing the port.
DUT(config-if)# no shutdown Open the port.
DUT(config-if)# exit Exit interface mode of interface eth-0-18
DUT(config)#exit Exit configuration mode
Bridge1
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree priority 0 Configure CIST priority to 0.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge2
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree instance 1 priority 0 Configure instance 1 priority to 0.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge3
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree instance 2 priority 0 Configure instance 2 priority to 0.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge4
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
8.5 Validation Commands
Verify the MSTP port state on Bridge1
DUT# show spanning-tree mst brief
##### MST0: Vlans: 1
Multiple spanning tree protocol Enabled
Root ID Priority 0 (0x0000)
Address d2ae.8baa.5b00
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 0 (0x0000)
Address d2ae.8baa.5b00
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec