CANOGA PERKINS 9175 Configuration Guide - Manual (Page 128)

CanogaOS Configuration Guide
20-5
R2
DUT# configure terminal Enter the Configure mode.
DUT(config)#router vrrp 1 Create a new VRRP session on the router and specify the VRID for the
session.
DUT(config-router)#virtual-ip
10.10.10.81 Set the virtual IP address for the VRRP session.
DUT(config-router)#interface eth-0-1 Specify the physical interface that will participate in virtual routing.
DUT(config-router)#priority 200 Configure the priority to 200 (less than 255) as R2 is the Backup router.
DUT(config-router)#preempt-mode true Set the preempt mode to specify that the highest priority will function as
a backup to master when master is unavailable
DUT(config-router)#
advertisement-interval 5 Configure the advertisement interval to 5 seconds.
DUT(config-router)# enable Enable the VRRP session 1 on the router.
DUT(config)# exit Exit Router mode and enter the Configure mode.
DUT(config)#router vrrp 2 Create a new VRRP session on the router and specify the VRID for the
session.
DUT(config-router)#virtual-ip
10.10.10.82 Set the virtual IP address for the VRRP session.
DUT(config-router)#interface eth-0-1 Specify the physical interface that will participate in virtual routing.
DUT(config-router)# preempt-mode true Set the preempt mode to specify that the highest priority will function as
a backup to master when master is unavailable
DUT(config-router)#
advertisement-interval 5 Configure the advertisement interval to 5 seconds.
DUT(config-router)# enable Enable the VRRP session 2 on the router.
DUT(config-router)# enable Enable the VRRP session 1 on the router.
DUT(config-router)# exit Exit Router mode and enter the Configure mode.
DUT(config)#router vrrp 2 Create a new VRRP session on the router and specify the VRID for the
session.
DUT(config-router)#virtual-ip
10.10.10.82 Set the virtual IP address for the VRRP session.
DUT(config-router)#interface eth-0-1 Specify the physical interface that will participate in virtual routing.
DUT(config-router)#priority 200 Configure the priority to 200 (less than 255) as R1 is the Backup router.
DUT(config-router)# preempt-mode true Set the preempt mode to specify that the highest priority will function as
a backup to master when master is unavailable
DUT(config-router)#
advertisement-interval 5 Configure the advertisement interval to 5 seconds.
DUT(config-router)# enable Enable the VRRP session 2 on the router.