CANOGA PERKINS 9175 Configuration Guide - Manual (Page 182)

CanogaOS Configuration Guide
28-3
DUT1#show mpls vc-table
VC-ID In Intf Out Intf In Label Out Label EndPoint Status Manual
200 eth-0-2 eth-0-1 3328 3328 192.168.10.10 Active No
28.3 VC configuration using static command
28.3.1 Configuring the VPWS on PE1
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#mpls-l2-circuit t2 ethernet Bind an interface to the Virtual Circuit.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# interface loopback 0 Enter the Interface mode.
• loopback0—Specify the loopback
interface name.
DUT1(config-if)#ip address 192.168.10.10/32 Create loopback addresses on both PE
routers. Use a /32 host route for the
loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls ftn-entry 192.168.11.1/24 111
8.8.8.2 Configure FTN entry for tunnel
DUT1(config)#mpls ilm-entry pop 222 Configure ILM entry for tunnel
DUT1(config)#mpls l2-circuit t2 201 192.168.11.10
manual Create a Virtual Circuit.
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address 8.8.8.1/24 Create IP address on the port.
DUT1(config-if)# label-switching Enable label-switching on interface
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls l2-circuit-fib-entry t2 444 333 Configure VC label for the VC.
28.3.2 Configuring the VPWS on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#mpls-l2-circuit t2 ethernet Bind an interface to the Virtual Circuit.