CANOGA PERKINS 9175 Configuration Guide - Manual (Page 116)

CanogaOS Configuration Guide
18-5
Total number of prefixes 4
DUT#show ip route
Codes: K - kernel, C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
[*] - [AD/Metric]
* - candidate default
C 1.1.1.0/24 is directly connected, eth-0-13
B 2.2.2.0/24 [20/0] via 1.1.1.1, eth-0-13, 00:03:33
B 3.3.3.0/24 [20/0] via 1.1.1.1, eth-0-13, 00:03:33
B 4.0.0.0/8 [20/0] via 1.1.1.1, eth-0-13, 00:03:33
K 192.168.100.0/24 is kernel directly connected, management interface
18.3 Basic topology( IBGP)
Figure 18-3: Basic BGP topology
Figure 18-4: IBGP topology
18.3.1 Configuration steps
18.3.2 Router A
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-13 Specify the interface (eth-0-13)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown Enable the interface.
AS100 AS100
BGP
Router A Router B
Eth-0-13 Eth-0-1 Eth-0-1
1.1.1.0/24 2.2.2.0/24
AS200
AS100
RIP
OSPF
Router A
Router B
IBGP EBGP