CANOGA PERKINS 9175 Configuration Guide - Manual (Page 80)

CanogaOS Configuration Guide
12-3
normal operating state for OAM on fully operational links.
FAULT
If OAM is reset, disabled, or the link timer expires, the Discovery process returns to the
FAULT state.
Validation Commands
DUT1#show ethernet oam eth-0-9
eth-0-9
Discovery State Machine Details:
------------------------------------------
EFM Discovery Machine State: Send Any
Local Parser State: Forward
Local Multiplexer State: Forward
Remote Parser State: Forward
Remote Multiplexer State: Forward
Local Client:
-------------
Frame Error:
Window: 100 x 100 milliseconds
Threshold: 1 Error Frame(s)
Last Window Frame Errors: 0 Frame(s)
Total Frame Errors: 00 Frames(s)
Total Frame Errors Events: 0 Events(s)
Relative Timestamp of the Event: 0 x 100 milliseconds
Frame Seconds Error:
Window: 1000 x 100 milliseconds
Threshold: 1 Error Second(s)
Last Window Frame Second Errors: 0 Frame(s)
Total Frame Second Errors: 00 Frames(s)
Total Frame Second Errors Events: 0 Events(s)
Relative Timestamp of the Event: 0 x 100 milliseconds
DUT1#show ethernet oam discovery interface eth-0-9
eth-0-9
Local client:
--------------
Administrative configurations:
Mode: active
Unidirection: supported
Link monitor: supported (on)
Remote Loopback: supported
MIB retrieval: not supported
MTU Size: 1518
Operational status:
Port status: operational
Loopback status: no loopback
PDU revision: 1
Remote client:
-----------------
MAC address: 0002.b33e.401d
Vendor(oui): 3 0 50
Administrative configurations:
Mode: active
Unidirection: supported
Link monitor: supported
Remote Loopback: supported
MIB retrieval: not supported
MTU Size: 1518