CANOGA PERKINS 9175 Configuration Guide - Manual (Page 19)

CanogaOS Configuration Guide
2-2
DUT1#configure terminal Enter the Configure mode.
DUT1(config-if)#static-channel-group 1 Add this interface to a static channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT1(config)#interface eth-0-7 Specify the interface (eth-0-7)to be configured and enter the
Interface mode.
DUT1(config-if)#static-channel-group 1 Add this interface to a static channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#end Return to privileged EXEC mode.
DUT1#show channel-group summary Verify the configuration.
Switch S2
DUT2#configure terminal Enter the Configure mode.
DUT2(config)#interface eth-0-5 Specify the interface (eth-0-5)to be configured and enter the
Interface mode.
DUT2(config-if)#no shutdown Enable the interface.
DUT2(config-if)#static-channel-group 1 Add this interface to a static channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT2(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT2(config)#interface eth-0-6 Specify the interface (eth-0-6)to be configured and enter the
Interface mode.
DUT2(config-if)#static-channel-group 1 Add this interface to a static channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT2(config-if)#no shutdown Enable the interface.
DUT2(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT2(config)#interface eth-0-7 Specify the interface (eth-0-7)to be configured and enter the
Interface mode.