CANOGA PERKINS 9175 Configuration Guide - Manual (Page 22)

CanogaOS Configuration Guide
3-2
DUT1#configure terminal Enter the Configure mode.
DUT1(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT1(config)#interface eth-0-2 Specify the interface (eth-0-2) to be configured and enter the
Interface mode.
DUT1(config-if)# channel-group 1 mode active Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT1(config)#interface eth-0-3 Specify the interface (eth-0-3) to be configured and enter the
Interface mode.
DUT1(config-if)# channel-group 1 mode active Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT1(config-if)#no shutdown Enable the interface.
DUT1(config-if)#end Return to privileged EXEC mode.
Switch S2
DUT2#configure terminal Enter the Configure mode.
DUT2(config)# lacp system-priority 1000 Set the system priority of this switch. This priority is used for
determining the system that is responsible for resolving
conflicts in the choice of aggregation groups. A lower
numerical value has a higher priority.
DUT2(config)#interface eth-0-1 Specify the interface (eth-0-1)to be configured and enter the
Interface mode.
DUT2(config-if)#no shutdown Enable the interface.
DUT2(config-if)# channel-group 1 mode active Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT2(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT2(config)#interface eth-0-2 Specify the interface (eth-0-2) to be configured and enter the
Interface mode.
DUT2(config-if)# channel-group 1 mode active Add this interface to channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.