CANOGA PERKINS 9175 Configuration Guide User Manual

Page 64

CanogaOS Configuration Guide

9-18

DUT(config) # interface eth-0-13

Enter the Interface mode.

DUT(config-vlan) # exit

Exit the interface mode and enter the Configure mode.

Configure and enable ERPS domain

DUT(config) # erps 2

Create erps domain with id 2.

DUT(config) # erps 2 primary control vlan 12

Set vlan 12 as the primary control vlan of erps domain
2.

DUT(config) # erps 2 ring 1 level primary

Create an erps primary ring 1 for domain 2.

DUT(config) # erps 2 ring 1 mode master

Set node as master of ring 1 for domain 2.

DUT(config) # erps 2 ring 1 primary interface eth-0-9

Set primary interface of ring 1 for domain 2.

DUT(config)# erps 2 ring 1 secondary interface eth-0-13

Set secondary interface of ring 1 for domain 2.

DUT(config) # erps 2 ring 1 enable

Enable ring 1 for domain 2.

DUT(config) # erps 2 enable

Enable domain 2.

9.5.3 Validation

Commands

Switch 1

Switch 2

DUT #show erps 1
ERPS domain ID: 1
ERPS domain name: ERPS001
ERPS domain primary control VLAN ID: 11
ERPS domain sub control VLAN ID: 0
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 3 second(s)
ERPS ring ID: 1
ERPS ring level: primary
ERPS ring 1 node mode: transit
ERPS ring 1 node state: link up
ERPS ring 1 primary interface name: eth-0-9
ERPS ring 1 secondary interface name: eth-0-20

DUT #show erps 2
ERPS domain ID: 2
ERPS domain name: ERPS002
ERPS domain primary control VLAN ID: 12
ERPS domain sub control VLAN ID: 0
ERPS domain hello timer interval: 1 second(s)