CANOGA PERKINS 9175 Configuration Guide - Manual (Page 25)

CanogaOS Configuration Guide
4-2
“show vlan classifier group” command displays all vlan classification groups, “show vlan
classifier rule” command displays all vlan classification rules.
DUT>enable
DUT#configure terminal Enter the Configure mode
DUT(config)#vlan database Enter the VLAN configuration mode
DUT(config-vlan)#vlan 5 Enable vlan5
DUT(config-vlan)#vlan 6 Enable vlan6
DUT(config-vlan)#exit Exit the vlan configuration mode
DUT(config)#vlan classifier rule 1 mac 2222.2222.2222 vlan 5 Create a mac-based VLAN classifier rule. This
rule will class all packets with source MAC
2222.2222.2222 to vlan 5
DUT(config)#vlan classifier rule 2 ip 1.1.1.1/24 vlan 5 Creat a subnet-based VLAN classifier rule.
This rule will class all packets with source IP
address in the subnet 1.1.1.1/24 to vlan 5
DUT(config)#vlan classifier rule 3 protocol ipv6 vlan 5 Creat a protocol-based VLAN classifier rule.
This rule will class all ipv6 packets to vlan 5.
DUT(config)#vlan classifier group 1 add rule 1 Creat a group of rules and add rule 1 to group
1)
DUT(config)#vlan classifier group 1 add rule 2 Add rule 2 to group 1
DUT(config)#vlan classifier group 1 add rule 3 Add rule 3 to group 1
Interface details
“show vlan classifier interface group” command displays all vlan classification on
interface.
DUT#configure terminal Enter configuration mode
DUT(config)#interface eth-0-1 Enter the interface mode.
DUT(config-if)#switchport access vlan 6 Assign PVID 6 to port eth-0-1
DUT(config-if)#switchport access allowed vlan add 5 Allowed VLAN 5 to port eth-0-1, for receiving
packets from VLAN 5.
DUT(config-if)#vlan classifier activate 1 based ip Apply group 1 on this port, and set this port’s
vlan class type to ip-based. Only ip-based vlan
class rule in group 1 can take effect on this port.
DUT(config-if)#exit Exit the interface mode.
DUT(config)#interface eth-0-2 Enter the interface mode.
DUT(config-if)#switchport access vlan 6 Assign PVID6 to port eth-0-2
DUT(config-if)#switchport access allowed vlan add 5 Allowed VLAN 5 to port eth-0-2, for receiving
packets form VLAN 5.
DUT(config-if)#vlan classifier activate 1 based mac Apply group 1 on this port, and set this port’s
vlan class type to mac-based. Only mac-based
vlan class rule in group 1 can take effect on this