CANOGA PERKINS 9175 Configuration Guide - Manual (Page 38)

CanogaOS Configuration Guide
7-2
7.4 Configurations
Bridge1
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree mode rstp Configure a spanning-tree mode.
DUT(config)# spanning-tree priority 4096 Configure the switch priority,the default
is 32768.
DUT(config)# interface eth-0-1 Specify the interface (eth-0-1)to be
configured and enter the Interface mode
DUT(config-if)# spanning-tree path-cost 200 Configure the cost for an interface.
DUT(config-if)# exit Exit the Interface mode and enter the
Configure mode.
DUT(config)# interface eth-0-4 Specify the interface (eth-0-4)to be
configured and enter the Interface mode
DUT(config-if)# spanning-tree port-priority 64 Configure the port priority for an
interface, the default is 128.
DUT(config-if)# exit Exit the Interface mode and enter the
Configure mode.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge 2
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree mode rstp Configure a spanning-tree mode.
DUT(config)# spanning-tree priority 12288 Configure the switch priority, the default
is 32768.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge 3
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree mode rstp Configure a spanning-tree mode.
DUT(config)# spanning-tree priority 32768 Configure the switch priority,the default
is 32768.
DUT(config)# spanning-tree enable Enable spanning tree protocol.
The default is enable
Bridge 4
DUT# configure terminal Enter the Configure mode.
DUT(config)# spanning-tree mode rstp Configure a spanning-tree mode.
DUT(config)# spanning-tree priority 16384 Configure the switch priority,the default