CANOGA PERKINS 9175 Configuration Guide - Manual (Page 113)

CanogaOS Configuration Guide
18-2
Figure 18-2: EBGP Topology
Following is the BGP configurations on Router A and Router B:
18.2.1 Configuration steps
18.2.2 Router A
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-13 Specify the interface (eth-0-13)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown Enable the interface.
DUT(config-if) # no switchport Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 1.1.1.1/24 Configure IP address to 1.1.1.1/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#interface eth-0-1 Specify the interface (eth-0-1)to be configured and enter the
Interface mode.
DUT (config-if)# no shutdown Enable the interface.
DUT(config-if) # no switchport Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 2.2.2.1/24 Configure IP address to 2.2.2.1/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#ip route 3.3.3.0/24 2.2.2.2 Add a static route 3.3.3.0/24 with nexthop 2.2.2.2
DUT(config)#router bgp 100 Creat bgp 100 and enter the router mode
DUT(config-router)#bgp router-id 10.10.10.10 Configure the bgp router-id
DUT(config-router)#neighbor 1.1.1.2 remote-as
200 Configure the ebgp neighbor with as 200
DUT(config-router)#network 4.0.0.0/8 Network the specified route 4.0.0.0/8
DUT(config-router)#redistribute static Redistribute the static route into bgp
DUT(config-router)#redistribute connected Redistribute the connect route into bgp
DUT(config-router)#exit Exit the router mode and enter the Configure mode.