CANOGA PERKINS 9175 Configuration Guide - Manual (Page 200)

CanogaOS Configuration Guide
30-7
Command Description
DUT1(config)#interface eth-0-9 Enter the Interface mode.
• eth-0-9—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#enable-ldp Configure Interface for LDP
DUT1(config-if)#ip address 4.4.4.2/24 Create IP address on the port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)#interface loopback 0 Enter the Interface mode.
• loopback0—Specify the loopback interface name.
DUT1(config-if)#ip address 11.11.11.11/32 Create loopback addresses on both PE routers. Use a
/32 host route for the loopback address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)# targeted-peer 10.10.10.10 Configure Targeted Peer in LDP.
DUT1(config-router)# transport-address 11.11.11.11 Configure Transport Address in LDP.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#mpls l2-circuit vc1 100 10.10.10.10 Create a Virtual Circuit.Both PE routers must be
configured with the same VC-ID.
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)#mpls-l2-circuit vc1 Bind an interface to the Virtual Circuit.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#router rip Enter the router-rip mode
DUT1(config-router)#network 4.4.4.0/24 Associate networks with the RIP process.
DUT1(config-router)#network 11.11.11.11/32 Associate networks with the RIP process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls enable-all-interfaces Enable label-switching on all interfaces.
30.3.5 Validation Commands
The validation commands used are show mpls ftn-forwarding, show mpls l2-circuit, show
mpls vc-table, ping mpls l2-circuit and traceroute mpls l2-circuit on PE1.
DUT1# show mpls ftn-forwarding
FEC Out-Label Nexthop Out-Intf
3.3.3.0/24 3 2.2.2.2 eth-0-12
4.4.4.0/24 1025 2.2.2.2 eth-0-12
11.11.11.11/32 1026 2.2.2.2 eth-0-12
DUT1# show mpls l2-circuit
VC-Name VC-ID Interface VC-type VLAN C-Word Manual
vc1 100 eth-0-1 Ethernet N/A 0 No
DUT1# show mpls vc-table
VC-ID PW Intf AC Intf L/R Label EndPoint Status Manual
100 eth-0-12 eth-0-1 1024/1024 11.11.11.11 Active No