CANOGA PERKINS 9175 Configuration Guide - Manual (Page 175)

CanogaOS Configuration Guide
27-4
DUT#configure terminal Enter the Configure mode.
DUT(config-router)# address-family vpnv4
unicast Enter vpnv4 address family
DUT(config-router-af)# neighbor 11.11.11.11
activate Activate the neighbor 11.11.11.11 in the vpnv4 address-family
DUT(config-router-af)#neighbor 11.11.11.11
send-community both Configure the neighbor to send-community both
DUT(config-router-af)# exit-address-family Exit the vpnv4 address-family and enter the router mode
DUT(config-router)#address-family ipv4 vrf 100 Enter the vrf address-family
DUT(config-router-af)#redistribute connected Redistribute the connect route into bgp vrf address-family
DUT(config-router-af)#redistribute static Redistribute the static route into bgp vrf address-family
27.2.4 PE2 (DUT3)
DUT#configure terminal Enter the Configure mode.
DUT(config)#interface eth-0-20 Specify the interface (eth-0-20)to be configured and enter the
Interface mode.
DUT (config-if)#no shutdown Enable the interface.
DUT(config-if) # no switchport Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 1.1.1.2/24 Configure IP address to 1.1.1.2/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#interface loopback 0 Specify the interface (loopback 0)to be configured and enter
the Interface mode.
DUT(config-if) # ip address 11.11.11.11/32 Configure IP address to 11.11.11.11/32.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#ip route 10.10.10.10/32 1.1.1.3 Add a static route 10.10.10.10/32 with nexthop 1.1.1.3
DUT(config)# ip vrf 100 Creat vrf with the name 100
DUT(config-vrf)#rd 1:100 Configure the rd value 1:100
DUT(config-vrf)#route-target both 1:100 Configure the route-target with both 1:100
DUT(config-vrf)#exit Exit vrf mode and enter the configure mode