CANOGA PERKINS 9175 Configuration Guide - Manual (Page 270)

CanogaOS Configuration Guide
45-3
45.3 Configuring the enable password
The enable password controls access to the privileged EXEC mode.
To set the enable password, follow these steps:
DUT# configure terminal Enter global configuration mode.
DUT(config)# enable password abc123 Define a new password or change an existing password
for access to privileged EXEC mode. By default, no
password is defined
To remove the password, use the no enable password global configuration command.
This example shows how to change the enable password to l1u2c3k4y5. The password
is not encrypted and provides access to level 15 (traditional privileged EXEC mode
access):
DUT(config)# enable password l1u2c3k4y5
45.4 Password recovery procedure
If the password is forgotten unfortunately, it can be recovered by following steps:
Step1: power on the system. Boot_loader will start to run. The follow information will be
printed on Console
CPU: MPC8247 (HiP7 Rev 14, Mask 1.0 1K50M) at 350 MHz
Board: 8247 (PCI Agent Mode)
I2C: ready
DRAM: 256 MB
In: serial
Out: serial
Err: serial
Net: FCC1 ETHERNET, FCC2 ETHERNET [PRIME]
Press ctrl+b to stop autoboot: 3
Step2: Press ctrl+b. stop autoboot.
Step3: under boot_loader interface, use the following instructions.
8247# boot_flash_nopass Load the device without start-config file under the
boot_loader mode through Console.
8247# Do you want to revert to the
default config file ? [Y|N|E]:
Press “Y”
Then system will reboot without loading startup-configuration. No password will be
required.
45.5 Validation
To display the co Commands nfigured users, use the show usernames privileged EXEC
command.
DUT#show usernames
Number User name Privilege Password Rsa Key
==============================================================
1 aaa 1 *
2 ccc 1 *
To display all the login information, use the show users privileged EXEC command.