CANOGA PERKINS 9175 Configuration Guide - Manual (Page 203)

CanogaOS Configuration Guide
30-10
Command Description
DUT1(config-router-af)#neighbor 11.11.11.11
send-community both Specify that a community attribute should be sent
to a BGP neighbor.
DUT1(config-router-af)#redistribute connected Redistribute connected routes in the VRF
DUT1(config-router-af)#redistribute static Redistribute static routes in the VRF
DUT1(config-router-af)#exit-address-family Exit the address family mode.
DUT1(config-router)#address-family ipv4 vrf vpn1 Enter the IPv4 address-family command mode.
DUT1(config-router-af)#redistribute connected Redistribute connected routes in the VRF
30.4.2 Configurations on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-12 Enter the Interface mode.
• eth-0-12—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#enable-ldp Configure Interface for LDP
DUT1(config-if)#ip address 2.2.2.2/24 Create IP address on the port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)#interface eth-0-17 Enter the Interface mode.
• eth-0-17—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#enable-ldp Configure Interface for LDP
DUT1(config-if)#ip address 3.3.3.1/24 Create IP address on the port.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#router rip Enter the router-rip mode
DUT1(config-router)#network 2.2.2.0/24 Associate networks with the RIP process.
DUT1(config-router)#network 3.3.3.0/24 Associate networks with the RIP process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls enable-all-interfaces Enable label-switching on all interfaces.
30.4.3 Configurations on PE3
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-17 Enter the Interface mode.