CANOGA PERKINS 9175 Configuration Guide - Manual (Page 189)

CanogaOS Configuration Guide
29-6
29.2.5 Validation Commands
Use the show ldp session and the show mpls vpls mesh commands respectively to
display complete information about theVPLS. The following are the sample outputs for
the show commands displaying VPLS.
PE1
DUT1#show ldp session
Peer IP Address IF Name My Role State KeepAlive
11.11.9.2 eth-0-9 Passive OPERATIONAL 30
11.11.3.3 eth-0-9 Passive OPERATIONAL 30
11.11.4.4 eth-0-9 Passive OPERATIONAL 30
DUT1#show mpls vpls mesh
VPLS-ID Peer Addr In-Label Out-Intf Out-Label Type
Lkps/St
100 11.11.3.3 3332 eth-0-9 3332 RAW 2/Up
100 11.11.4.4 3333 eth-0-9 3336 RAW 2/Up
PE2
DUT1#show ldp session
Peer IP Address IF Name My Role State KeepAlive
11.11.1.1 eth-0-13 Active OPERATIONAL 30
11.11.9.2 eth-0-13 Passive OPERATIONAL 30
11.11.3.3 eth-0-13 Active OPERATIONAL 30
DUT1#show mpls vpls mesh
VPLS-ID Peer Addr In-Label Out-Intf Out-Label Type
Lkps/St
100 11.11.1.1 3336 eth-0-13 3333 RAW 2/Up
100 11.11.3.3 3337 eth-0-13 3333 RAW 2/Up
PE3
DUT1#show ldp session
Peer IP Address IF Name My Role State KeepAlive
11.11.1.1 eth-0-17 Active OPERATIONAL 30
11.11.9.2 eth-0-17 Passive OPERATIONAL 30
11.11.4.4 eth-0-17 Passive OPERATIONAL 30
DUT1#show mpls vpls mesh
VPLS-ID Peer Addr In-Label Out-Intf Out-Label Type
Lkps/St
100 11.11.1.1 3332 eth-0-17 3332 RAW 2/Up
100 11.11.4.4 3333 eth-0-17 3337 RAW 2/Up
P
DUT1#show ldp session
Peer IP Address IF Name My Role State KeepAlive
11.11.1.1 eth-0-9 Active OPERATIONAL 30
11.11.3.3 eth-0-17 Active OPERATIONAL 30
11.11.4.4 eth-0-13 Active OPERATIONAL 30
29.3 Configuring VPLS using static conmmand
29.3.1 Configuring the VPLS on PE1
Command Description