CANOGA PERKINS 9175 Configuration Guide - Manual (Page 192)

CanogaOS Configuration Guide
29-9
29.3.3 Configuring the VPLS on PE3
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address 11.11.11.3/24 Create IP address on the port.
DUT1(config-if)# label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#mpls ftn-entry 13.13.13.1/32 310
11.11.11.4 Configure one static FTN entry.
DUT1(config)#mpls ftn-entry 11.11.11.3/32 320
11.11.11.4 Configure one static FTN entry.
DUT1(config)# mpls vpls vpls1 1 Create a VPLS instance and come into the VPLS
instance mode.
DUT1(config-vpls)#vpls-peer 13.13.13.1 raw manual Add a PE for VPLS instance.
DUT1(config-vpls)#vpls-peer 12.12.12.2 raw manual Add a PE for VPLS instance.
DUT1(config)#interface eth-0-4 Enter the Interface mode.
• eth-0-4—Specify the interface
DUT1(config-if)#mpls-vpls vpls1 Bind an interface to a VPLS instance.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#vpls-fib-add vpls1 peer 13.13.13.1
301 103 Add a static PW for a PE in a VPLS instance.
DUT1(config)#vpls-fib-add vpls1 peer 12.12.12.2
302 203 Add a static PW for a PE in a VPLS instance.
29.3.4 Configuring the VPLS on P
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address 11.11.11.4/24 Create IP address on the port.
DUT1(config-if)#label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface