CANOGA PERKINS 9175 Configuration Guide - Manual (Page 144)

CanogaOS Configuration Guide
24-2
might be destined to the group IP address rather than to the all-routers address.
24.2.1 References
The IGMP module is based on the following RFC:
RFC 1112
RFC 2236
24.2.2 Configuring IGMP Parameter
There is no explicit command to enable IGMP, which is always combined with PIM-SM.
When PIM-SM is enabled on an interface, IGMP will be enabled automatically on this
interface, vice versa. But notice, before IGMP can work, IP Multicast-routing must be
enabled globally firstly.
Enable IGMP
DUT>enable Enter Privilege Exec mode
DUT#configure terminal Enter Configuration mode
DUT(config)#ip multicast-routing Enable IP Multicast routing globally
DUT(config)#interface eth-0-1 Enter interface eth-0-1
DUT(config-if)#no switchport Change eth-0-1 as routed port
DUT(config-if)#ip address 10.10.10.10/24 Set the interface IP address
DUT(config-if)#ip pim sparse-mode Enable ip pim sparse mode
Configuring IGMP interface parameters
DUT>enable Enter Privilege Exec mode
DUT#configure terminal Enter Configuration mode
DUT(config)#interface eth-0-1 Enter interface eth-0-1
DUT(config-if)#ip igmp version 2 Set igmp version
DUT(config-if)#ip igmp query-interval 120 Set igmp query interval
DUT(config-if)#ip igmp query-max-response-time 12 Set igmp query max response time
DUT(config-if)#ip igmp robustness-variable 3 Set igmp robustness value
DUT(config-if)#ip igmp last-member-query-count 3 Set igmp last member query count
DUT(config-if)#ip igmp last-member-query-interval 2000 Set igmp last member query
interval
Limit Max IGMP Group number
The limit can be configured globally or per interface
DUT>enable Enter Privilege Exec mode
DUT#configure terminal Enter Configuration mode
DUT(config)#ip igmp limit 2000 Set global max igmp group number