CANOGA PERKINS 9175 Configuration Guide - Manual (Page 254)

CanogaOS Configuration Guide
39-5
authorized state or 802.1x disabled on this port.
Default 802.1x Configuration
Feature Default setting
RADIUS server
• IP address
• UDP authentication port
• Key
• None specified.
• 1812.
• None specified.
Switch IEEE 802.1x enable state Disabled.
Per-interface IEEE 802.1x enable
state Disabled (force-authorized).
The port sends and receives normal traffic without IEEE
802.1x-based authentication of the client.
Periodic re-authentication Disabled.
Number of seconds between
re-authentication attempts
3600 seconds.
Re-authentication number 2 times (number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state).
Quiet period 60 seconds (number of seconds that the switch remains in
the quiet state following a failed authentication exchange
with the client).
Retransmission time 30 seconds (number of seconds that the switch should
wait for a response to an EAP request/identity frame
from the client before resending the request).
Client timeout period 30 seconds (when relaying a request from the
authentication server to the client, the amount of time the
switch waits for a response before resending the request
to the client.
Authentication server timeout period 30 seconds (when relaying a response from the client to
the authentication server, the amount of time the switch
waits for a reply before resending the response to the
server. This setting is not configurable.)
Authentication server active period 5 minutes. (after a specified number of attempts failure to try the server,
the server will transition to sleeping mode, the time from sleeping mode
to active again is called active period)
Enabling IEEE 802.1x authentication