CANOGA PERKINS 9175 Configuration Guide - Manual (Page 20)

CanogaOS Configuration Guide
2-3
DUT2#configure terminal Enter the Configure mode.
DUT2(config-if)#static-channel-group 1 Add this interface to a static channel group 1 and enable link
aggregation so that it can be selected for aggregation by the
local system.
DUT2(config-if)#no shutdown Enable the interface.
DUT2(config-if)#end Return to privileged EXEC mode.
DUT2#show channel-group summary Verify the configuration.
2.4 Validation Commands
DUT1#show channel-group summary
Flags: D - down/admin down B - in Bundle
R - Layer3 S - Layer2
U - in use
Aggregator Name Protocol Ports
----------------+------------+-------------------------------------------
-
agg1(SU) Static eth-0-5(B) eth-0-7(B) eth-0-6(B)
DUT1#
DUT1#show interface agg1
Interface agg1
Interface current state: UP
Hardware is AGGREGATE, address is 1e24.0c97.0905 (bia 1e24.0c97.0905)
Bandwidth 2000000 kbits
Index 155 , Metric 1 , Encapsulation ARPA
Speed - 1000Mb/s , Duplex - Full , Media type is Link Aggregation
Link speed type is autonegotiation, Link duplex type is autonegotiation
Input flow-control is off, output flow-control is off
The Maximum Frame Size is 1534 bytes
VRF binding: not bound
Label switching is disabled
No virtual circuit configured
ARP timeout 01:00:00, ARP retry interval 1s
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 222 bits/sec, 0 packets/sec
0 packets input, 0 bytes
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 input errors, 0 CRC
0 frame, 0 overrun, 0 pause input
0 input packets with dribble condition detected
4093 packets output, 229266 bytes, 0 underruns
0 output errors, 0 collisions, 0 late collision
0 no carrier, 0 pause output