Install printer paper – Welch Allyn 246 Propaq CS Vital Signs Monitor v.3.7X - User Manual User Manual
Page 89
Directions for Use
Maintenance
85
Install printer paper
1.
Lay the monitor on its back to gain access to the bottom of the printer.
2.
Squeeze the locks on the paper door and pull out to open it.
3.
Lift the paper roll from the holder and pull out any paper remaining in the printer.
4.
Place the new paper roll onto the spindle on the door as shown, and pull out several
inches of paper.
5.
Slide the end of the paper into the printer slot until it extends out the side.
6.
Close the paper door and turn the monitor upright.
7.
Simultaneously press the START/STOP and PRINT TRENDS button. Confirm the
monitor prints a test print similar to the following:
Caution Use only low-debris printer paper listed in Welch Allyn Products and
Accessories. Use of other paper can cause unclear printing of patient data,
printhead damage, and eventual printer failure. Store all paper (including a
monitor loaded with paper) in compliance with paper storage specifications
(